Re: PenCentra130

[risyu@zo-kun.to]

はじめまして、中津と申します。

私も最近このマシンを購入してトライしてます。
#秋葉のQC-Passで9,800円

serial consoleを試したところ、途中までブートするのですが、
root file system type: ffs
で止まってしまいます。

とりあえず、hackしようと思いますが、
boot logを付けるので、なにか気付いた事があればご指摘頂けないでしょうか。

ブート時はInterTopを選択しています。
液晶は凍ったままですが、
pcicはちゃんとCFを検出しているようです。

------------------
mem_cluster_cnt = 2
mem_clusters[0] = {0x0,0x65e000}
mem_clusters[1] = {0x65e000,0x9a2000}
loading 0x65e000,0x9a2000
Copyright (c) 1996, 1997, 1998, 1999, 2000
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.5 (RAMDISK) #0: Sat Nov 18 19:46:04 JST 2000
    shin@touji:/u/obj/release/sys/arch/hpcmips/compile/RAMDISK
MIPS VR 4121 (NEC VR4121 rev1.0 131.072MHz)
total memory = 16384 KB
avail memory = 8584 KB
using 230 buffers containing 920 KB of memory
/u/src/release/src/sys/arch/hpcmips/vr/vr.c(294): vr_bus_reset() not implemented
.
mainbus0 (root)
cpu0 at mainbus0: NEC VR4100 CPU (0xc60) Rev. 6.0 with software emulated floatin
g point Rev. 0.0
cpu0: L1 cache: 16KB/16B instruction, 8KB/16B data, direct mapped
cpu0: No L2 cache
cpu0: install VR specific idle routine
vrip0 at mainbus0
vrcmu0 at vrip0 addr 0xb000060-0xb00007f
vrgiu0 at vrip0 addr 0xb000100-0xb00011f intr 8
pwctl0 at vrgiu0 port=15 id=0 on=1
vrbcu0 at vrip0 addr 0xb000000-0xb00001f
vrbcu: cpu 131.072MHz, bus 32.768MHz, ram 65.536MHz
com0 at vrip0 addr 0xc000000-0xc000007 intr 9: ns16550a, working fifo
com0: console
vrrtc0 at vrip0 addr 0xb0000c0-0xb0000df intr 2
vrkiu0 at vrip0 addr 0xb000180-0xb00019f intr 7
wskbd0 at vrkiu0 mux 1
vrpmu0 at vrip0 addr 0xb0000a0-0xb0000bf intr 1
vrdsu0 at vrip0 addr 0xb0000e0-0xb0000e7
vrpiu0 at vrip0 addr 0xb000120-0xb0002bf intr 5
wsmouse0 at vrpiu0 mux 0
vrisab2 at vrgiu0:ISA port 0x15000000-0x18000000 mem 0x10000000-0x20000000
isa2 at vrisab2
pcic0 at isa2 port 0x3e0-0x3e1 iomem 0x70000-0x73fff irq 393219
pcic0: controller 0 (Intel 82365SL Revision 1) has sockets A and B
pcic0: controller 1 (Intel 82365SL Revision 1) has socket A only
pcmcia0 at pcic0 controller 0 socket 0
pcmcia1 at pcic0 controller 0 socket 1
pcmcia at pcic0 controller 1 socket 0 not configured
bivideo0 at mainbus0: pseudo video controller
hpcfb0 at bivideo0: hpcrasops 640x480 pixels, 256 colors, 80x48 chars: tvram red
raw
wsdisplay0 at hpcfb0
wsdisplay0: screen 0 added (std, vt100 emulation)
btnmgr0 at mainbus0
wskbd1 at btnmgr0 mux 1
hpcapm0 at mainbus0: pseudo power management module
apmdev0 at hpcapm0: Power Management spec V1.2
/u/src/release/src/sys/arch/hpcmips/vr/vr.c(294): vr_bus_reset() not implemented
.
pcic0: using irq 393219 for socket events
 fixed, 8192 blockswdc1 at pcmcia0 function 0 port 0x15000300-0x1500030f
wd0 at wdc1 channel 0 drive 0: <LEXAR ATA FLASH>
wd0: drive supports 1-sector pio transfers, lba addressing
wd0: 48384 KB, 756 cyl, 4 head, 32 sec, 512 bytes/sect x 96768 sectors
boot device: wd0
root on md0a dumps on md0b
WARNING: preposterous clock chip time
 -- CHECK AND RESET THE DATE!
root file system type: ffs

--------------------
--------
りしゅ@ぞーくんと <risyu@zo-kun.to>